Supers

Lane · Post by **Lane** » Sun Jan 25, 2009 8:24 am

How do you cut the hand hold in your supers?

Post by **Wally** » Sun Jan 25, 2009 1:22 pm

The supers I buy and resell are just cut with a 3/4 inch dado blade for 3 or 4 inches.

ski · Post by **ski** » Sun Jan 25, 2009 3:06 pm

The few that I have made were done with a sliding cut off saw or miter saw that allows the depth to be set. Then it was just a matter of bringing the blade down move the board a little and repeat until you have the width you want.
A dado sure would be a lot nicer to use.
I read on another site where it was done as above and then they took a gouge or rounded chisel and scoped out the bottom of the slot if you will to give that nice transition.